The Secret of IP67 Protection

Over the last year I have been discussing IP rated products with people in various positions  in the manufacturing world and I have encountered some false assumptions about IP67 protection.  I want to quickly go over what an IP67 test actually is and then go into the assumptions I’ve seen.

IP67 Testing Requirements:
1)  Dust-tight and complete protection against contact.
2)  Protected from the effects of being completely immersed in 1 meter of water for 30 minutes at a constant temperature.

Assumption #1 – My product has an IP67 rating, if I use it, I have IP67 protection.

Actually if a product has an IP67 rating on it’s datasheet, its IP67 capable, not protected.  If you have to connect to or open something on the product, these are points of failure.  If the device requires a connector, the connector and subsequent o-ring all need to be seated properly to actually give you an IP67 rating.  This usually involves reaching a specific torque rating on the connector or some  type of clasp/lock.

Assumption #2 – I have a lot of fluids in my manufacturing process, IP67 is not good enough.

Most people have had bad experiences in the past with IP67 devices and heavy fluid presence.  Most of the time, Assumption #1 plays a lot into these experiences.  When your products are properly IP67 sealed, you can definitely have moderate contact with fluids  or immersion.  Now application to application, it of course needs to be reviewed, but it’s worth investigating because higher protection ratings have higher dollar amounts attached to them.

When choosing sensors, connectors or other products for most automation applications, just remember that IP67 is only IP67 when installed properly.

Check out how to guarantee your IP67 ratings in this one-page PDF.


Share/Bookmark
//

This entry was posted in Analog Position Sensors, Cables and Connectors, Capacitive Sensors, Inductive Proximity Sensors, Luminescence Sensors, Magnetic Field Sensors, Photoelectric Sensors and tagged , , , , , , , . Bookmark the permalink.

3 Responses to The Secret of IP67 Protection

  1. Pingback: Defining IP Ratings and NEMA Ratings « SensorTech

  2. balaji.v says:

    my product should support IP67 protection , my product has to te installed with connectors as well, is there any specefic calculation for meeting the requirement?

  3. Will Healy III says:

    Great question, and to be honest, I am not aware of an exact equation to determine IP67 for a connection; but I am guessing that it is related to the gasket/o-ring selected. That being said, if possible, the IP67 should still be tested against the standard testing procedures presented by the IEC publication 529 and the DIN standard number 40050.

    On the connectors and cordsets I am responsible for, the gasket/connector combination requires that an M8 connector be torqued to 0.4 N-m without exceeding that value. If torqued to the proper spec, the connector will be IP67.

What do you think?

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s